TSL202R
128 y 1 LINEAR SENSOR ARRAY
TAOS032F  JANUARY 2012
8
r
r
Copyright E 2012, TAOS Inc.
The LUMENOLOGY r Company
www.taosinc.com
APPLICATION INFORMATION
It is good practice on initial power up to run the clock (n+1) times after the first SI pulse to clock out indeterminate
data from power up. After that, the SI pulse is valid from the time following (n+1) clocks. The output will go into
a high-impedance state after the n+1 high clock edge. It is good practice to leave the clock in a low state when
inactive because the SI pulse required to start a new cycle is a low-to-high transition.
The integration time chosen is valid as long as it falls in the range between the minimum and maximum limits
for integration time. If the amount of light incident on the array during a given integration period produces a
saturated output (Max Voltage output), then the data is not accurate. If this occurs, the integration period should
be reduced until the analog output voltage for each pixel falls below the saturation level. The goal of reducing
the period of time the light sampling window is active is to lower the output voltage level to prevent saturation.
However, the integration time must still be greater than or equal to the minimum integration period.
If the light intensity produces an output below desired signal levels, the output voltage level can be increased
by increasing the integration period provided that the maximum integration time is not exceeded. The maximum
integration time is limited by the length of time the integrating capacitors on the pixels can hold their accumulated
charge. The maximum integration time should not exceed 100 ms for accurate measurements.
Although the linear array is capable of running over a wide range of operating frequencies up to a maximum
of 5 MHz, the speed of the A/D converter used in the application is likely to be the limiter for the maximum clock
frequency. The voltage output is available for the whole period of the clock, so the setup and hold times required
for the analog-to-digital conversion must be less than the clock period.
相关PDF资料
TSL208R IC LINEAR SENSOR ARRAY 512X1
TSL210 IC LINEAR SENSOR ARRAY 640X1
TSL230BRD-TR IC LIGHT TO FREQUENCY CONV 8SOIC
TSL235RSM-LF IC LIGHT TO FREQUENCY CONV 3SMD
TSL237SM-LF IC LIGHT TO FREQUENCY CONV 3SMD
TSL237T IC LIGHT TO FREQUENCY CONV 4-TMB
TSL238D-TR IC LIGHT TO FREQUENCY CONV 8SOIC
TSL238T IC LIGHT TO FREQUENCY CONV 4-TMB
相关代理商/技术参数
TSL208 制造商:未知厂家 制造商全称:未知厂家 功能描述:512 X 1 LINEAR SENSOR ARRAY
TSL208R 功能描述:光学开关,专业型 Linear Array 200 DPI RoHS:否 制造商:ams 感应方式: 安装风格:Through Hole 封装:Tube
TSL210 功能描述:光频率和光电压 Linear Array 200 DPI RoHS:否 制造商:ams 峰值波长:1000 nm 工作电源电压:5 V 最大工作温度:+ 85 C 最小工作温度:- 25 C 安装风格: 封装 / 箱体:
TSL213 制造商:Rochester Electronics LLC 功能描述:- Bulk
TSL213A 制造商:Rochester Electronics LLC 功能描述:- Bulk
TSL214 制造商:Rochester Electronics LLC 功能描述:- Bulk
TSL215 制造商:TI 制造商全称:Texas Instruments 功能描述:128 】 1 INTEGRATED OPTO SENSOR
TSL216 制造商:未知厂家 制造商全称:未知厂家 功能描述:Optoelectronic